9 mTorr in order to decrease the etching rate [32, 33]. Vertical sidewalls could be produced using a 20 W radio frequency forward power (≈50 V DC bias) and a 150 W ICP

power, as demonstrated in Figure 1. Figure 1 Top and profile images of dry etched-holes. SEM images of holes after dry etching with resist remaining on the surface. Regularly shaped circular holes are observed in the top view (a) while the profile in (b) shows the vertical sidewalls. The resist is affected near the holes and pushed back. Therefore, the holes increase with etching time in lateral dimension. Using this etching recipe, the depth and shape of the holes can be influenced separately, and also, the shape of the hole in the resist is transferred https://www.selleckchem.com/screening/apoptosis-library.html almost 1:1 into the underlying GaAs substrate. After etching, the resist was removed by an adequate remover mainly consisted of acetone, followed by cleaning with different solvents (trichlorethylene, acetone, n-methyl-2-pyrrolidone) and dipping in a heated ultrasonic bath (isopropyl acolhol, methanol, ethanol), as also performed in prior studies [29]. The cleaning procedure was finalized

with a 35 min plasma asher treatment in oxygen atmosphere and a 10 s dip into diluted hydrochloric acid. A 12 nm thin GaAs buffer layer is deposited followed by a small annealing step for 20 s in order to reduce surface roughness created during etching. The beam equivalent pressures were ≈8×10-9 bar for As and ≈3.5×10-10 bar for Ga. The CA3 mw InAs QDs are grown for 24 s, which is equivalent to 1.5 ML. For all steps, the substrate temperature was held at 500°C. The influence of the hole properties, e.g., the hole shape, was then investigated by comparing the amount of QDs nucleated in the holes. Information on these properties were obtained from scanning electron microscopy (SEM) images using the image analysis tool ImageJ (NIH, Bethesda, MD, USA) [34]. The depth of the holes was obtained from atomic force

microscopy (AFM) scans. Results and discussion At first, the influence of the hole ADAMTS5 size on the nucleation of QDs per hole (occupation) was investigated and is shown in Figure 2. The hole diameters were calculated from the surface area of the holes which was extracted from SEM images by ImageJ. The original hole sizes were equal for all three etching times (10, 15, and 20 s), but lateral etching leads to larger holes at longer etching times due to the push back of the resist as demonstrated in Figure 1. Despite strong size fluctuations, which possibly resulted from imperfections of the electron beam exposure, an increase of QD occupation is observed for larger hole diameters. This is in agreement with the work of GSK872 Jeppesen et al. [5]. Figure 2 Dependence of the nucleating QDs per hole on the diameter. The number of QDs that nucleate inside a hole is dependent on the hole diameter.