e., the beam is directed through the fused silica substrate onto the SiO x film (Figure 1b). To determine the intensity distribution in the image plane on the sample, the sample is removed, and this plane is imaged onto a UV-sensitive CCD camera using a × 100 UV microscope objective (Ultrafluar, Carl Zeiss, Oberkochen, Germany) (Figure 1c). Irradiation experiments with high spatial resolution were carried out using a standard ArF excimer

laser emitting at 193 nm with pulse duration of about 20 ns. In this case, a Schwarzschild-type reflective objective (NA = 0.4, ×25 demagnification) was used for mask projection. A scanning electron microscope (Zeiss DSM 962) has been used to investigate selleckchem the laser-induced morphological changes. Results Figure 2 displays SiO x films irradiated with a crossed grating pattern with and without PDMS confinement layer (after peeling off https://www.selleckchem.com/products/empagliflozin-bi10773.html this layer). In both cases, the film disintegrates with a period given by the beam pattern, whereas the fused silica substrate remains

intact. Confinement leads to smooth, contiguous features around the ablation sites instead of irregular splashes observed without this confinement. Figure 2 Influence of confinement. Patterned 150-nm-thick SiO x film irradiated (a) without and (b) with confinement (after peeling off the confinement layer); laser parameters: 248 nm, 260 mJ/cm2, 1 pulse. To establish a correlation between the irradiation pattern and the resulting grid pattern, beam profiles in the sample plane have been recorded (Figure 3). In the case of a large period of the mask (40 μm), the intensity pattern is a four times PF299804 chemical structure reduced, but congruent, image of the transmission pattern of the mask (a). In the case of the 20-μm mask period, the beam pattern is already Fenbendazole a bit blurred due to the limited resolution of the projection optics (f). The corresponding grid patterns obtained at various fluences are also displayed in Figure 3. At low fluence, in the case of a period large compared to the optical resolution, the film detaches from the substrate in the area of the irradiated cross

pattern forming hollow channels, but keeping contact to the substrate in the non-irradiated areas (b). For the smaller period, only some buckling of the film at the high intensity crossing points is observed (g). Increasing the fluence, after enlargement of the detached area (c, h), rupture of the film in between the crossing points of the channels and formation of openings in the detached film occur (d, i). At still higher fluence, the enlargement of the openings (e) and the formation of thin wires of residual material between these openings (k) are observed. However, at the positions of minimum intensity, this wire grid is still connected to the substrate. Depending on the fluence and the particular intensity pattern, other types of shaping can be observed, e.g., hollow channels or arrays of blisters or cup-like structures.