Top graph illustrates

the Raman spectra obtained from the bottom position (curve A) or the small-particle position on the EG (curve B). (d) Bottom graph illustrates the Raman spectra acquired from the bottom (curve C) and the particle position (curve D) of the GOx surface. The inset images show magnified views of the areas indicated by the white circles. Figure  2b shows an optical image of a GOx surface that had been freshly fabricated by treatment with benzoic acid (see Figure  1). Contrasting with Figure  2a, the GOx surface clearly displayed two regions: a bottom region and a particle region. As with the EG surface, the Raman spectra were collected at these two positions. As expected, the particle position (marked (D)) yielded a distinct Raman spectrum, whereas

the bottom position (marked (C)) displayed a typical EG surface spectrum, with the G band at 1,597.6 cm–1. Figure  2f shows that the graphene oxide spectrum was measured 3-deazaneplanocin A purchase with a high intensity. Note that the G band (1,613.1 cm–1) obtained from the particle position was shifted toward higher wavenumbers relative to the G bands of graphene and graphite. The ratio of the D and G band intensities, ID/IG, is inversely proportional to the average size of the sp 2 domains. The Raman D/G intensity ratio for the GOx surface was found to be 0.92, similar to the results reported previously for graphene oxide [18]. A Raman spectrum similar to the spectrum of GO surface indicated that benzoic acid treatment successfully yielded a GOx surface. The EG and GOx surfaces were used in the subsequent experiments involving BYL719 mw the oxidation of aniline, which is difficult to oxidize in general. We hypothesized that only the GOx surface would be able to oxidize aniline if the oxidation process is

possible. Because the oxidation of aniline on a GOx surface could not be fully characterized by micro Raman spectroscopy alone, we obtained the core-level spectra of the N 1 s peak, which is an indicator of the overall molecular electronic properties. The morphological discrepancies observed between the optical images could only be explained in terms of a surface reaction, as AZD5153 supported by the HRPES results. Figure  3 shows the surface-sensitive N 1 s core-level spectra Janus kinase (JAK) of aniline on the EG and GOx surfaces, obtained using HRPES at 460 eV photon energy. The N 1 s core spectra of 3,600 L aniline on EG or on GOx surfaces were obtained first. As expected, the presence of aniline resulted in low-intensity nitrogen peaks on the EG surface because the EG surface was too inert to react to the oxidation of aniline, illustrated in Figure  3a. The N 1 s core-level spectrum was then obtained after preparing a sample to have 3,600 L aniline on the GOx surface. Two distinct nitrogen peaks corresponding to the aniline peak (NH2 is marked N1) and azobenzene peak (NO2 is marked N2) clearly appeared, as shown in Figure  3b, indicating that the oxidation reaction had proceeded as we expected.