For the separation of sucrose, the zeolites CaX and MgX presented the most promising results, since they adsorbed about 250 g/L after 60 min of reaction. The amount of glucose adsorbed after 60 min increased according to the following

sequence of zeolite forms: Ba2+ < Mg2+ < Ca2+ < K+ < Sr2 < Na+. Considering the fructose separation, the amount adsorbed increased according to the following sequence of zeolite forms: Sr2 < Ca2+ < K+ < Mg2+ < Ba2+ < Na+. Considering the sucrose separation, the amount adsorbed increased according to the following sequence of zeolite forms: K+ < Na+ < Sr2 < Ba2+ < Ca2+ < Mg2+. Ribociclib ic50 Heper et al. (2007) evaluated the separation of glucose and fructose using the Y zeolite. Considering the fructose adsorption, the amount adsorbed increased

according to the sequence NH4+ < Mg2+ < Na+ < Ca2+, while the amount of glucose adsorbed increased according to the sequence NH4+ < Mg2+ < Ca2+ < Na+. These results are similar to the one obtained in this work. Gramblicka & Polakovic (2007) reported the capacity of the adsorbents Diaion, Dowex, Lewatit and Amberlite to recovery of individual saccharides and verified that the adsorbed amounts decreased in the order fructose > glucose > sucrose > kestose > nystose > fructofuranosylnystose. In addition, Gramblicka & Polakovic (2007) verified that the sieve effect of the resins were the primary cause of the Cabozantinib different partitioning of the investigated saccharides between the solid and liquid phases. This also explains that no effect of the concentration on the distribution coefficients was observed at the multicomponent adsorption from the mixture of FOS. The authors also Phosphoribosylglycinamide formyltransferase assumed

that obtained isotherms for individual FOS were not affected by the presence of other species of the mixture. The low performance of the BaX zeolite to recovery glucose could be due to the fact that the hydrated Ba ions cannot migrate into the sodalite unit and the hexagonal prism during ion exchange because of their large ionic radii. They occupy positions in the supercage and can interact with the adsorbents even at a low degree of exchange (Schöllner, Einicke, & Gläser, 1993). Based on the experimental results, the most appropriated forms to separate glucose, fructose and sucrose from the reaction medium are the forms NaX, NaX or BaX and MgX or CaX, respectively. Nevertheless, the choice of the most appropriated form to separate these sugars can be made according to a numerical analysis of the model parameters in terms of adsorption rates and mass transfer resistances involved in the process. In this sense, therefore, the experimental data from Fig. 1 were used to estimate the model parameters for each zeolite form, which are presented at Table 1. Before the analysis of the model parameters, some aspects concerning the convergence and stability of the parameter estimation should be overviewed.